Proudly Made in the USA
AAA Plumbing proudly supports Zoeller world class quality pumps. Made in the USA, Zoeller pumps are designed to operate in the harshest of environments.
Residential Use Sewage Pump
-
Float-operated, submersible (NEMA 6), 2-pole switch
-
Durable, cast iron construction – switch cap, motor and pump housing
-
Engineered plastic base
-
Stainless steel screws, bolts, handle, guard, arm and seal assembly
-
Corrosion-resistant, powder coated epoxy finish
-
Hermetically-sealed, automatic reset thermal overload protection
-
Upper and lower sleeve bearings running in bath of oil
-
Carbon and ceramic shaft seal
-
Passes 2” (50 mm) spherical solids
-
2” NPT discharge
-
On point: 12-1/2” (31.8 cm)
-
Off point: 4-1/2” (11.4 cm)
-
Simplex and duplex systems available
-
Automatic and non-automatic models available
-
Non-automatic for variable level systems
-
Models available packaged with piggyback variable level float switch
-
3 year limited warranty
Commercial Use Sewage Pump
-
Durable, ASTM Class 25 cast iron motor housing cover and pump housing
-
Engineered plastic base on model 270
-
Not affected by materials normally found in drainage and sewage sumps
-
Stainless steel screws, bolts and handle
-
Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor
-
Neoprene square ring & gasket
-
Carbon and ceramic shaft seal
-
4270 series double seal pump available
-
Cast iron base on 4270
-
Upper sleeve bearing and lower ball bearing running in a bath of oil
-
Passes 2” (50 mm) spherical solids
-
2” NPT discharge
-
Corrosion-resistant, powder coated epoxy finish
-
Models available packaged with a piggyback variable level float switch
-
Simplex and duplex systems available
-
Packaged systems available
-
1 year limited warranty
Commercial Use Sewage Pump
-
Durable, cast iron constructed switch case, motor and pump housing, base and impeller
-
No sheet metal parts to rust or corrode
-
All cast iron class 30 30000# tensile strength
-
Stainless steel screws, bolts, float rod, handle, guard and arm and seal assembly
-
Shaft seal – Carbon and ceramic rotary face seal, with stainless steel wetted parts
-
SAE 1117 carbon steel motor shaft (single seal models)
-
Upper and lower ball bearing running in bath of oil
-
Maximum temperature for sewage or dewatering: 130 °F (54 °C)
-
Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor (1 Ph and auto 3 Ph)
-
All models available in 2” or 3” discharge
-
All models pass 2” (50 mm) spherical solids.
-
Automatic units available with float-operated, submersible mechanical switch**
-
Corrosion-resistant, powder coated epoxy finish
-
On point: 15-1/4” (38.7 cm)
-
Off point: 5-1/4” (13 cm)
-
Major width: 13-9/16” (34.4 cm) (single seal pumps)
-
Major height: 19-9/16” (49.7 cm) (single seal pumps)
-
Automatic or non-automatic with single seal
-
Non-automatic with double seals
-
1 or 3 Ph motors available
-
See selection chart for specifications or specific models
-
1 year limited warranty
Get in Touch
Beecher, Illinois
708.855.3272